Annette's tutorial for a Tri Fold Card with Tag Insert for challenge 87.

Thank you so much to Annette for allowing us to share this tutorial with you. You can also find it here if you would like to print it out or download it in pdf format.

　
TRI-FOLD CARD with TAG INSERT

Instructions and Template written by Annette Dayot
Studio A Paper Creations

READ ALL DIRECTIONS BEFORE BEGINNING!

PAPER SUPPLY

Cardstock pieces for Card Base:


(1) Piece: 10½” x 5” – Score at 5” and 10”


(1) Piece: 5” x 5” (for flap)


Cardstock piece for Tag Insert: 9” x 5” – Score at 4¼”


Patterned paper for layering: (2) pieces 4” x 4¼
 
TOOLS



Adhesive Tape Glue


Ruler Photo Corner Punch


⅛” Circle Punch (or Hole Puncher)


Score Board Tool

TRI-FOLD CARD with TAG INSERT  

Cut and Score CARD BASE and
CARD FLAP pieces as shown in Figure 1











 

Assemble the CARD BASE by attaching the Card Flap piece to the Card Base piece as shown in Figure 2. Apply adhesive to the ½” flap

This is how your card should look like so far.

Open assembled card base and make diagonal cuts as shown in RED in Figure 3.

• If you would like to decorate or add a 
patterned paper to line the inside of the tri-fold card, do so now.

 

• In my sample I added a piece of patterned
paper, size: 4¾” x 4¾”
• Apply adhesive along the bottom of the center panel as shown.   

• Fold the right flap over as pictured.




 

• To decorate the outer panels, cut a contrasting 4¾” x 4¾” piece of patterned paper, and then cut in half diagonally.

 

• Your assembled TRI-FOLD should look like this. 









 

  Cut and Score piece for the TAG INSERT as shown in Figure 2.
• Cut cardstock for TAG INSERT to measure 5” x 9”
• Score at 4¼”, then fold 
 
 
 

Prepare the TAG INSERT as shown in Figure 3
On the right hand side of the card:
• Measure 2½” down from the upper right corner; make a small mark with a pencil.
• Punch a hole where you made the pencil mark.
 

 
• Create a tab just below the hole using a photo corner punch.


 

TIP:
I used a photo corner punch to make the “tab”.
To do this I removed the plastic guide from my photo corner punch.

 
• Cut (3) pieces of 4” x 4¼” patterned paper.
• Adhere one square on the front panel of the
TAG INSERT.
• Adhere one square on each panel on the inside
the TAG INSERT.

• Here is the base for the TRI-FOLD CARD and the TAG INSERT. From here you can add your image(s) and/or sentiments & embellishments as desired.

Finished TRI-FOLD CARD & TAB INSERT